Epson SureColor F6070 User's Guide download pdf (Page 20)

Introduction 20

Notes When Using the Printer

Note the following points when using this printer to avoid breakdowns, malfunctions, and

print quality decline.

O When using the printer, observe the operating temperature and humidity range

described in the “Specifications Table”. See “Specifications Table” on page 96.

Even when the conditions above are met, you may not be able to print properly if the

environmental conditions are not suitable for the paper. Be sure to use the printer in an

environment where the paper’s requirements are met. For more details, see the

documentation supplied with the paper.

Also, when operating in dry areas, air conditioned environment, or under direct sunlight,

maintain the appropriate humidity.

O Do not install the printer next to heat sources or directly in the path of air from a

ventilator or air conditioner. Failure to observe this precaution could result in the print

head nozzles drying and clogging.

O The print head may not be capped (i.e., may not move to the right side) if an error

occurs and the printer is turned off without first resolving the error. Capping is a function

for automatically covering the print head with a cap (lid) to prevent the print head from

drying out. In this case, turn on the power and wait a while until capping is performed

automatically.

O When the power is on, do not remove the power plug or cut the power at the breaker.

The print head may not be capped properly. In this case, turn on the power and wait a

while until capping is performed automatically.

O Even when the printer is not in use, some ink will be consumed by head cleaning and

other maintenance operations needed to keep the print head in good condition.

Notes When Not Using the Printer

If you are not using it, note the following points when storing the printer. If it is not stored

correctly, you may not be able to print properly the next time it is used.

O If you do not print for a long time, the print head nozzles may become clogged. Turn the

printer on at least once every two weeks to prevent the print head from clogging.

When the printer is turned on, head cleaning is performed automatically. Do not turn the

printer off until cleaning is complete.

Leaving the printer for too long without turning it on may result in a malfunction. Repair

work for such malfunction will be charged.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 110 111

No comments

Epson SureColor F6070 User's Guide Page 20