Epson SureColor F6070 User's Guide Page 83

  • Download
  • Add to my manuals
  • Print
  • Page
    / 111
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 82
Problem Solver 83
Chapter 5
Problem Solver
What to Do When a Message Is Displayed
If the printer displays one of the messages shown below, refer to the solution listed and
take the necessary steps.
Message What to do
Chip Unit Error
Chip unit not recognized.
Reattach or replace.
O Reattach the chip unit. If the message persists, replace with a new
chip unit.
See “Replacing and Refilling Consumables” on page 67.
O Condensation may have formed inside the ink pack. Store at room
temperature for at least 4 hours.
See “Notes on Handling Ink Packs and Ink Tanks” on page 21.
Chip Unit Error
Chip unit not recognized.
Refill after matching ink
pack with label?
Attach the chip unit included with the specified genuine Epson ink
pack. You cannot use any genuine Epson ink packs other than the one
specified.
See “Options and Consumable Products” on page 93.
Chip unit expended.
Replace chip unit.
The chip unit is nearing the end of its lifetime and needs to be
replaced. Obtain a replacement ink pack for the appropriate color as
soon as possible.
See “Options and Consumable Products” on page 93.
See “Notes on Handling Ink Packs and Ink Tanks” on page 21.
F/W Install Error
Firmware update failed.
Restart the printer.
Turn the printer off, wait for a few minutes, and then turn on the printer
again.
Use EPSON LFP Remote Panel 2 to re-attempt the update.
If this message appears on the LCD panel again, contact Epson
Support.
Command Error
Check print settings on RIP.
Press the
W button and select Job Cancel to stop printing. Check to
confirm that the installed software RIP is compatible with your printer.
Paper Cut Error
Remove uncut paper.
After pressing the OK button, pull out the paper and cut along the line
of the failed cut using scissors or a third-party cutter.
Align the end of the paper with all the poster board supports and press
the OK button.
Page view 82
1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 110 111

Comments to this Manuals

No comments