Epson TM-U925 User Manual download pdf (Page 17)

Setting Up the Printer 1-7

3. Plug in the power supply's cable as shown below. Notice that

the flat side of the plug faces down.

Note:

To remove the DC cable connector, make sure that the power

supply's power cord is unplugged; then grasp the connector at the

arrow and pull it straight out.

Grounding the Printer

When you use the printer as a single unit (not connected to an

intelligent module), you need an appropriate ground wire to

ground your printer.

1. Make sure that the printer is turned off.

2. Connect the ground wire to the printer using the FG screw on

the bottom of the printer, as shown.

U925_eng.book Page 7 Thursday, July 25, 2002 9:15 AM

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 57 58

No comments

Epson TM-U925 User Manual Page 17