Epson TM-U925 User Manual download pdf (Page 24)

1-14 Setting Up the Printer

Notes:

1. When pin 6 of the interface connector is used for the reset signal, the printer is

reset at MARK on the RS-232C level.

2. When pin 25 of the interface connector is used for the reset signal, the printer

is reset at SPACE on the RS-232C level or at HIGH on the TTL level.

3. DIP switches excluding switch 2-1 (Auto line feed) and switches 2-7 and 2-8

(interface reset signal) are effective only while the printer power is turned on.

If the DIP switch setting is changed after the printer power is turned on, the

change is not effective.

4. If DIP switch 2-7 or 2-8 is on while the printer power is turned on, the printer

may be reset, depending on the signal state. DIP switches should not be

operated while the printer power is turned on.

Changing the DIP switch settings

If you need to change settings, follow the steps below to make your

changes:

Set 2

SW Function ON OFF

Factory

settings

2-1 Auto line feed Always enabled Always disabled OFF

2-2 Receive buffer 32 bytes 2048 bytes OFF

2-3

Font selection

(default)

9 x 9 7 x 9 OFF

2-4

Carriage speed

(default for paper

roll printing)

Low High OFF

2-5

Handshaking (BUSY

condition)

Receive buffer-full

Off-line or

receive buffer-full

OFF

2-6 Internal use Fixed - ON

2-7 I/F pin 6 reset signal Enabled Disabled OFF

2-8 I/F pin 25 reset signal Enabled Disabled OFF

U925_eng.book Page 14 Thursday, July 25, 2002 9:15 AM

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 57 58

No comments

Epson TM-U925 User Manual Page 24