Epson EMP-TW100 Installation Guide download pdf (Page 8)

Turning On the Projector

This section describes the procedure from turning on the power to projecting images.

Procedure

Check that the power is turned off for

the projector and all components

connected to the projector.

Connect the computer or other video

source to the projector.

Refer to the Setup Guide.

Remove the lens cover.

Connect the accessory power cord to

the projector.

Check that the power cord connector is facing the

same way as the power inlet on the projector, and

then insert the power cord connector securely into

the projector.

Connect the other end of the power

cord to a grounded electrical outlet.

Turn on the main power switch at the

rear of the projector.

Wait until the indicator lights orange.

Connecting the Power Cord

The buttons on the projector control panel

and remote control cannot be operated

while the indicator is flashing orange.

Wait until it lights steadily.

Be sure to read the separate

Safety Instructions/World-Wide Warranty Terms

and check the

points that must be noted before using the projector to project images.

Place your finger

under the top of the

lens cover and pull

to remove the cover.

Lights orange

Downloaded From projector-manual.com

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 67 68

No comments

Epson EMP-TW100 Installation Guide Page 8