Epson EMP-TW100 Installation Guide download pdf (Page 9)

Basic Operations

Procedure

Turn on the power for all equipment

connected to the projector.

For a video source, press the [Play] button at the

video source to start playback if necessary.

Check that the indicator on the projector has

stopped flashing and lights orange.

Press the [Power] button on either the

remote control or the projector's

control panel to turn on the power.

The indicator flashes green, and after a short

period projection starts.

Check that the indicator has stopped flashing

and lights green. (This takes approximately 15

seconds.)

If more than one signal source has been connected, use the remote control or

control panel buttons to select the port which the signal source that you

would like to use is connected to, while referring to the following table.

*The display disappears after 2 seconds.

Turning On the Power and Projecting Images

The buttons on the remote control and the projector's control panel cannot be operated

while the indicator is flashing green. Wait until it lights steadily.

The message "No-Signal." may appear depending on the projector's menu settings. (p.30)

Port

Button to press

Display at top-right of

screen *

Projector Remote control

InputA

[Source]

[A] INPUT A

InputB [B] INPUT B

S-Video [S-Video] S Video

Video [Video] Video

D-RGB/A-RGB DVI-I

[D-RGB] D-RGB

[A-RGB] A-RGB

•

••

•

If only one signal source has been connected, the signals from that source will be

projected without needing to press one of the above buttons.

•

••

•

If the "No-Signal." message does not disappear, check the connections again.

•

••

•

If a laptop computer or a computer with an LCD screen has been connected to the

projector, the images may not be projected straight away. After making the connections,

check that the computer has been set up to output signals.

The following table shows examples of how to toggle output settings. For details, refer to

the section of the documentation provided with your computer under a heading such as

"External output", "Connecting an external monitor" or similar.

Lights green

Remote control

NEC Panasonic Toshiba IBM Sony Fujitsu Macintosh

[Fn]+[F3] [Fn]+[F3] [Fn]+[F5] [Fn]+[F7] [Fn]+[F7] [Fn]+[F10]

After startup, change the

Control Panel adjustments

so that Mirroring is active.

Connecting the Power Cord

Turning On the Power and Projecting Images

Downloaded From projector-manual.com

Basic Operations

Retract the front adjustable foot if it is

extended.

Gently push down on the projector while pressing

the foot adjust button.

Attach the lens cover.

Attach the lens cover to the lens when not using

the projector, in order to stop the lens from

getting dusty or dirty.

Downloaded From projector-manual.com

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 67 68

Comments to this Manuals

No comments

Epson EMP-TW100 Installation Guide Page 9

Comments to this Manuals

Related products and manuals for Data projectors Epson EMP-TW100