Epson ActionLaser 1600 EPL-5600 User Manual download pdf (Page 14)

Gently slide the cartridge into the slot until it lochs in place.

Turn on the printer.

Once you insert the cartridge, you need to use SelecType™ to

select the EpsonScript emulation mode. See “Selecting the

EpsonScript Emulation Mode” later in this chapter.

To remove the cartridge, turn off the printer and remove the

cartridge by grasping it at the center and gently pulling it

straight out.

Installing

the EpsonScript

board

This section describes how to install the EpsonScript board if

you have an EPL-5600 or ActionLaser 1600 printer.

You install the EpsonScript board on the printer’s controller

board. To install the EpsonScript board, you need to first

remove the controller board as described in the "Options”

chapter of your printer manual.

Caution:

Do not attempt to remove the controller board unless the

printer is off and the power cord is unplugged. Removing the

controller board exposes the electrical components inside the

printer. These components may be very hot if the printer has

been used recently. Also, try not to touch the contacts on the

board because many

the components can be damaged by

static electricity.

Setting Up 1-3

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 69 70

No comments

Epson ActionLaser 1600 EPL-5600 User Manual Page 14