Epson Software Film Factory v3.0 User's Guide download pdf (Page 51)

Page 51

Port Setup (Token Ring)

A Token Ring option is not available for the RIP Station. Therefore, these Setup options

cannot be selected.

TO CONFIGURE PROTOCOL SETUP:

• Click the Protocol Setup tab in the Network Setup window.

The RIP Station can accept jobs via TCP/IP (over Ethernet only), AppleTalk, and IPX/SPX

simultaneously. To conﬁgure the RIP Station, choose each protocol and enter the settings

for that protocol.

Protocol Setup (TCP/IP)

Enable on Ethernet—Click to enable if you have a TCP/IP network connected to the

RIP Station over Ethernet cabling.

You must enable TCP/IP for Ethernet to use Fiery WebTools over Ethernet. If you are

using TCP/IP for printing from Windows NT 4.0 workstations, enabling TCP/IP here also

enables you to use Fiery utilities from Windows NT 4.0 workstations using TCP/IP proto-

cols.

IP Address (Ethernet)—Enter the RIP Station IP address for Ethernet. You must change

the default 127.0.0.1 to a valid address for your network. For information about setting up

printing with TCP/IP, see Chapter 3 in the Administrator Guide.

Subnet Mask (Ethernet)—If you need to set the subnet mask, enter one of the following

values:

• 255.0.0.0 if the IP address starts with a number less than 128

•

255.255.0.0 if the IP address starts with a number from 128 through 191

• 255.255.255.0 if the IP address starts with a number greater than 191

NOTE: Be sure to conﬁrm the subnet mask setting with your network administrator before

proceeding. In some cases, the required setting may be different from those listed.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 59 60

No comments

Epson Software Film Factory v3.0 User's Guide Page 51