Epson Stylus Pro 7710 User's Guide download pdf (Page 47)

Taking up your prints

When the Auto Take-up Reel Unit is installed, and the

take-up reel core is loaded with paper to take up in the

desired direction, you can use the unit to take up your

prints.

Warning:

Do not touch the Auto Take-up Reel Unit while

it is operating. Doing so may result in injury.

Set the Auto switch to Forward or Backward.

Send a print job to the printer.

The printer starts printing. The Auto Take-up

Reel Unit takes up the roll paper in the

direction you set in step 1.

Note:

When printing by using the Roll Auto Cut On

set the Auto switch of the Auto Take-Up Reel Unit to

Off, otherwise the printer does not cut the paper. You

can set the Auto switch to Off during printing to cut

the paper automatically.

Removing paper after take-up

After paper take-up, follow the steps below to remove

the take-up reel core.

Set the Auto switch to Off.

Cut the roll paper.

❏ Press the

button to cut the roll paper.

❏ If the roll paper cannot be cut with the

built-in cutter, use a scissors or cutter sold

at a store.

Turn the lever to unlock the movable unit, and

then slide it to the left so that the flange knob

clears the end of the take-up reel core.

While doing this, support the take-up reel core

with one hand to keep it from falling.

Epson Stylus Pro 7700/7710/9700/9710 User’s Guide

Paper Handling

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 186 187

No comments

Epson Stylus Pro 7710 User's Guide Page 47