Epson TM-J2000 Specifications Page 299

  • Download
  • Add to my manuals
  • Print
  • Page
    / 761
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 298
CONFIDENTIAL
Paper roll Status commands DLE EOT
Ver. 10.05 p. 299
Waiting for the FEED button to be pressed when removing a label (when the peeling detector
cannot detect a label due to sunlight)
Error cause status (n = 3)
If the cause of the recoverable error (bit 2) is a paper layout error, the printer can recover from the
error by opening/closing the roll paper cover or by the DLE ENQ command, or pressing the paper
feed button only when memory switch Msw 8-1 or Msw 8-2 is OFF. See Function 3 of GS E.
Bit 3 is not supported.
Continuous paper detection status (n = 4)
When the cover is open, the status of the roll paper end sensor (bit 5, 6) retain the value when the
cover was closed immediately before.
Peeler status (n = 8, a = 3)
Bit 0: When the continuous issuing mode is selected, this bit is always 0.
Bit 2: When the peeling issuing mode is selected, this bit is changed during paper feeding or when
a label is in the peeling position. When label removal is checked by pressing the paper feed
button, this bit may be incorrect. When the continuous issuing mode is selected, this bit is always
1.
Models other than the TM-L90 with Peeler
The default value is set by Msw 1-3.
Error cause status (n = 3)
If the cause of the recoverable error (bit 2) is a paper layout error, the printer can recover from the
error by opening/closing the roll paper cover or by the DLE ENQ command, or pressing the paper
feed button only when memory switch Msw 8-2 is OFF. See Function 3 of GS E.
Continuous paper detection status (n = 4)
When the cover is open, the status of the roll paper end sensor (bit 5, 6) retain the value when the
cover was closed immediately before.
Page view 298
1 2 ... 294 295 296 297 298 299 300 301 302 303 304 ... 760 761

Comments to this Manuals

No comments