CONFIDENTIAL
Paper roll Miscellaneous commands GS ( Q
Ver. 10.05 p. 462
■ x2L, x2H, y2L, y2H set the line drawing end coordinate [X end position, Y end position] as the start
position reference.
• X end position: [(x2L + x2H × 256) × horizontal and vertical motion units]
• Y end position: [(y2L + y2H × 256) × horizontal and vertical motion units]
■ m1 sets the type of line. The line width differs according to the model (refer to the model information).
[Notes]
■ This function can be used when page mode is selected. Select page mode with ESC L.
■ You cannot specify a start coordinate [X start position, Y start position] and end coordinate [X end
position, Y end position] that exceed the printing area set with ESC W.
■ You cannot specify a start coordinate [X start position, Y start position] and end coordinate [X end
position, Y end position] that are the same coordinate.
■ Lines that can be drawn are lines horizontal in relation to characters (Y start position = Y end position) and
lines vertical in relation to characters (X start position = X end position). Diagonal lines cannot be specified.
■ X and Y and the horizontal and vertical motion units used for the start position specified with ESC T are
changed as shown in the table below.
m1 Line type
1 Continuous line: Thin
2 Continuous line:
Moderately thick
3 Continuous line: Thick
Comments to this Manuals