CONFIDENTIAL
Paper roll Customize commands GS ( E
Ver. 10.05 p. 681
• If the communication conditions between the host and printer no longer match, the printer is no
longer able to receive data from the host. Also data sent from the printer cannot be received by the
host.
■ This function operates in the user setting mode.
■ The communication conditions set with this function are valid when <Function 2> of this command is
executed. Then the printer operates with the changed communication conditions. If the host is not
changed to the same communication conditions, communication is not possible.
■ The communication conditions set are valid until the following operations are executed. They are not
initialized when the power is turned off or by ESC @.
• This function is executed.
• The wireless communication initialization mode is executed using the panel switch when the power is
turned on.
[Model-dependent variations] TM-J2000/J2100, TM-T90, TM-T88IV, TM-T70, TM-L90, TM-P60, TM-U220
TM-J2000/J2100, TM-T90, TM-T88IV, TM-T70, TM-L90, TM-U220
This function is not supported.
TM-P60
This function is enabled with a Bluetooth interface model.
If the communication conditions of the Bluetooth interface are changed with this function, always
finish the user setting mode with <Function 2> of this command. If you turn off the power or
perform reset between executing this function and executing <Function 2>, the Bluetooth
interface communication conditions are not changed.
Comments to this Manuals