CONFIDENTIAL
Paper roll Customize commands GS ( E
Ver. 10.05 p. 690
TM-L90
In the following cases, the parameter is the wrong value. If these parameters are processed, the
value is not set.
When sa = “49“
sb ≤ sd
sb ≤ se
sb < sf
width of paper < sg + sh + 33
(when width of paper is less than or
78 mm {3.1 inches})
width of paper < sg + sh + 43
(when width of paper is less than or
79 mm {3.1 inches})
width of paper < sg + sh + 53
(when width of paper is less than or
80 mm {3.1 inches})
When sa = “64“
sd < sc
sc ≤ se
sb < sg + sf
width of paper < sg + sh + 53
Take the following into consideration if die-cut labels are used:
The cutting position se must be set between the labels. It is also recommended to cut the label as
far as possible from the top or the bottom of the label.
The print position (sd , sf) (top and bottom margin) must be set over 1.5 mm from the top and the
bottom of the label.
The print position (sg , sh) (left and right margin) must be set over 2.8 mm from the left and the
right of the label.
If the distance between the cutting position and the next print starting position is set to 3.6 mm
or less, the printer cannot perform feeding in reverse to set the print starting position on the
current label during standby at label peeling position.
Comments to this Manuals