CONFIDENTIAL
Paper roll Miscellaneous commands GS ( Q
Ver. 10.05 p. 467
■ If the line width is 2 dots or more, the line is thickened towards the center of the rectangle. However, if the
specified rectangle size is smaller than the line width, the line is not thickened in excess of the size of the
rectangle.
■ When this function is executed, the printing position does not change.
[Model-dependent variations] TM-P60
TM-P60
The vertical and horizontal motion units are about 0.125 mm {1/203 inch}. This corresponds to 1
dot pitch.
The line width of this printer is as shown in the table below.
ESC T start
position Start position/end position
Horizontal and vertical motion units
used
Top left or bottom
right
X: Vertical in relation to paper feed
direction (horizontal direction of
characters)
X: Horizontal (vertical in relation to paper
feed direction)
Y: Paper feed direction (vertical direction
of characters)
Y: Vertical (paper feed direction)
Top right or
bottom left
X: Paper feed direction (horizontal
direction of characters)
X: Vertical (paper feed direction)
Y: Vertical in relation to paper feed
direction (vertical direction of characters)
Y: Horizontal (vertical in relation to paper
feed direction)
m1 Line type Line width
1 Continuous line: Thin 2 dots
2 Continuous line:
Moderately thick
4 dots
3 Continuous line: Thick 8 dots
Comments to this Manuals