CONFIDENTIAL
Paper roll Miscellaneous commands GS ( P
Ver. 10.05 p. 457
■ If the maximum settable area is exceeded, the following corrective action is taken.
• If the specified horizontal size exceeds the maximum settable area [horizontal size = maximum value
for the printable area] is set.
• If the specified (horizontal offset + horizontal size) exceeds the maximum settable area [horizontal
offset = (maximum value for the printable area - horizontal size)] is set.
• If the specified vertical size exceeds 1,016 mm {40 inches}, [vertical size = 1,016 mm {40 inches}] is set.
• If the maximum value for the area size specified by the model is exceeded, the corrective action
specified by the model is executed.
■ If the horizontal and vertical motion units are changed after the printable area is set, the printable area
set does not change.
■ When using the page mode with models that support this function, the following rules apply.
• The printable area set with this function is the maximum value for the area that can be specified with
ESC W.
• The top left of the printable area set with this function is treated as the absolute origin of ESC W.
• If the printable area is changed with this function, after executing ESC L and FS L, set the printing
area to the same size as that specified in ESC W with this function.
■ The setting value of this function is valid until ESC @ESC @, reset, or power off are executed.
■ Settings of this function do not affect printing in standard mode.
[Model-dependent variations] TM-P60
TM-P60
The vertical and horizontal motion units are about 0.125 mm {1/203 inch}. This corresponds to 1
dot pitch.
For this printer, the horizontal size of the printable area cannot be changed with this command.
Always specify [(wxL + wxH × 256) = 65535]. The horizontal size of the printable area is decided by
the setting value for FS ( L <Function 33> paper layout (sm or sf). See the FS ( L <Function 33>
model information for details.
Comments to this Manuals