CONFIDENTIAL
Paper roll Character commands ESC SP
Ver. 10.05 p. 92
■ It is used to change the spacing between characters.
[Model-dependent variations] TM-J2000/J2100, TM-T90, TM-T88IV, TM-T70, TM-L90, TM-P60, TM-U230,
TM-U220
TM-J2000/J2100, TM-T90, TM-T88IV,TM-T70, TM-L90
The vertical or horizontal motion unit is specified by GS P.
TM-P60
The horizontal or vertical motion unit is approximately 0.125 mm {1/203 inches}. This value equals
one dot pitch.
TM-U230
The horizontal motion unit is 0.159 mm {1/160 inch}. This value equals a half dot pitch. This
command does not use the vertical motion unit because the printer does not support page mode.
TM-U220
The horizontal motion unit is 0.159 mm {1/160 inch}. This value equals a half dot pitch. This
command does not use the vertical motion unit because the printer does not support page mode.
Program Example for all printers Print Sample
PRINT #1, CHR$(&H1D);"P";CHR$(180);CHR$(180);
PRINT #1, CHR$(&H1B);" ";CHR$(0); ← Character spacing set to 0
PRINT #1, "AAAAA"; CHR$(&HA);
PRINT #1, CHR$(&H1B);" ";CHR$(6); ← Character spacing set to 6
PRINT #1, "BBBBB"; CHR$(&HA);
PRINT #1, CHR$(&H1B);" ";CHR$(12); ← Character spacing set to 12
PRINT #1, "CCCCC"; CHR$(&HA);
AAAAA ← 0-inch character spacing
BBBBB ←
6/180-inch character spacing
CCCCC ← 12/180-inch character spacing
Comments to this Manuals